Reglaze a bathtub it’s a really tricky project. Tricky if you don’t follow the directions very carefully the project will not turn out. need a bucket sponge and a heavy-duty cleaner like TSP, face mask, gloves, triple-zero steel wool, and a spray-on epoxy. After an initial cleaning of the bathtub, scrubbed down with a tsp substitute trisodium phosphate. Use steel wool, and scrub the surface and make sure that it’s ready to accept paint. Get some gloves on and take the pad of steel wool and just make a circular pattern. Look on the pad just that little bit of buffing. We can see residue with the paint, then wipe out all the residue with some warm water. The cleaning is finally over and protects the surrounding areas with painters tape and our plastic tarps. Cover fixtures, floor, and tape along the wall. Be careful not to spray the paint too close to the tub, otherwise, most of these paints will give you as a pili finish. So keep the can somewhere about 10 inches away from the tub. Make sure that the area is well-ventilated windows opens.